: Connect the high-speed CAN bus cables into the marked input/output ports. If the DO 3001 sits at the physical end of the communication line, you must plug in a 120-ohm terminating resistor connector to eliminate signal echoing.
Clear the sensor gap entirely so no material blocks it. Navigate to the sensor calibration menu and sample the "Unblocked" value. Erhardt-leimer Do 3001 Manual
What specific (e.g., DC 23, DC 03, CAN bus system) is this sensor connected to? Are you facing a specific fault code or functional issue? : Connect the high-speed CAN bus cables into
The DO 3001 operates on an optical infrared principle. It projects an infrared light beam across a measuring gap to a receiver. When a material web passes through this gap, it blocks a portion of the light. The sensor measures this interruption to determine the exact position of the web edge. Key Technical Data Navigate to the sensor calibration menu and sample
Activate the "Automatic" mode to begin web guiding.