Each digital and analog pin is arranged in a 3-pin stack, typically labeled , V , and S : G (Ground): Connects to the GND or 0V pin on your sensor. V (Voltage): Connects to the 5V or VCC pin on your sensor.
Select for Trig. Run a female-to-female jumper wire from the sensor's Trig pin to the S pin of row 2. arduino sensor shield v5 0 manual
Cons
Connecting servos, ultrasonic sensors, and motor drivers. Each digital and analog pin is arranged in
The header also provides Vcc and GND. This interface was originally designed for SD card modules, but you can also connect any other SPI device – for example, an Ethernet controller or an SPI‑based sensor – as long as you respect the voltage levels. arduino sensor shield v5 0 manual