: Solder thin jumper wires (typically 0.1mm) to the CLK, CMD, and DAT0 points. You can often power the board using a USB cable instead of soldering VCC/VCCQ to avoid thermal damage.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Technical - Samsung M01s ( M017f isp pinout - Facebook samsung m017f isp pinout
Apply a microscopic amount of flux to the CLK, CMD, and DAT0 pads. Tin your jumper wire. Gently solder the wires to the components. Keep the wire lengths under 5 to 7 centimeters to prevent signal degradation and data corruption. Step 4: Connect to the Flashing Box : Solder thin jumper wires (typically 0