Acer Q65h2-am: V1.1 Manual

Turn off the system completely and pull out the AC power line cord. Move the small plastic jumper block from pins 1-2 over onto pins 2-3. Keep it bridged for 15 seconds. Relocate the jumper back onto pins 1-2 before plugging the computer back into wall power. Official Support Documentation & Driver Access

Connects the case's master physical power button. Bridge these two pins to toggle system startup. Orientation does not matter. acer q65h2-am v1.1 manual

If you’re looking at this board today, you’re likely trying to wire it into a new case. Without the manual, the header is a notorious guessing game. Community experts often point to this standard configuration: Pins 1-3 : HDD LED (be careful with polarity!) Pins 5-7 : Reset Switch Pins 6-8 : Power Switch A Word of Caution Turn off the system completely and pull out

The most frustrating part of using this board in a new case is the front panel header. Acer typically uses a 14-pin layout. Here is the most common configuration found by the community: Pin Numbers Observe polarity (+ on 1, - on 3) Observe polarity Reset Switch Orientation doesn't matter Power Switch Short these to turn the PC on Typically used in OEM cases Rear I/O Overview Relocate the jumper back onto pins 1-2 before