Esa Vtwin 524 36 Top !!top!! -

This guide covers the identification, installation, wiring, and troubleshooting for the ESA VTwin 524-36.

1. Product Identification Model: ESA VTwin (Safety Light Curtain) Protected Height: 524 mm Number of Beams: 36 (This determines the resolution/protection level). Resolution: Typically 14mm or 30mm depending on the specific sub-version.

14mm: Finger protection. 30mm: Hand protection.

Note: "Top" usually refers to the mounting bracket orientation or identifying the unit as the top half of a cascaded system. 2. Safety Precautions WARNING: This is a safety device. Incorrect installation can result in serious injury or death. esa vtwin 524 36 top

Installation and configuration must be performed by qualified personnel. Ensure the power is off before wiring. Verify the unit is rated for your specific safety category (e.g., SIL 2, SIL 3, PL d, PL e) before commissioning.

3. Mechanical Installation

Mounting: The VTwin series usually features a standard M5 mounting slot on the rear. Alignment: Resolution: Typically 14mm or 30mm depending on the

The Transmitter (Sender) and Receiver must face each other directly. The maximum range is typically up to 15-20 meters (check your specific datasheet). The 524mm height measures the sensitive zone. Ensure this zone covers the access point entirely so an operator cannot reach over, under, or around without breaking the beam.

Top Mounting: If using "Top" brackets, ensure they are rated for the vibration and environmental conditions of your machinery.

4. Electrical Wiring Guide The ESA VTwin typically uses an M12 connector or cable assembly. Note: "Top" usually refers to the mounting bracket

Pinout (Standard M12 - 5 Pin):

Pin 1: +24V DC (Power) Pin 2: 0V (Ground) Pin 3: Output Signal (OSSD 1) Pin 4: Output Signal (OSSD 2) Pin 5: Test/Enable or Blank (depending on configuration)