Me7.4.5 Pinout - ^new^

Are you planning to this ECU or are you performing a stage 1 remap ?

for full system reading/writing (MICRO + EEPROM), technical guides from Piasini Engineering specify the following hardware modifications: Add Resistors : Install two 6.8k ohm (6K8) resistors as part of the boot circuit. Remove Resistor me7.4.5 pinout

Tools like DFB Technology allow for a full read and write of the Micro and EEPROM (typically a 95320 eeprom ) via these pinout connections. Essential Precautions Are you planning to this ECU or are

To interface with the ME7.4.5 for bench work or programming, specific pin connections are required for power, ground, and communication. : Power Supply (+12V) : Ignition (Switched +12V) : K-Line (Communication) POL4 & POL5 me7.4.5 pinout